Does It Doom Bower Power Jimmy Bower Signature Overdrive Pedal

New

Does It Doom Bower Power Overdrive Pedal

From the infamous crucible of the New Orleans underworld, channeling the raw anguish and scathing fury that defined a genre…

For the first time harness the quintessential sound of southern suffering with the all-new Jimmy Bower Signature Overdrive.

The Power of the Riff Compels You!

A collaboration with Nick Williams of the mighty Dunwich Amplification.


Take As Needed for Gain...

Four-knob overdrive for downtuned guitar and bass

The Bower Power Overdrive is the combination of a classic op-amp overdrive and a solid state power amp boost. The pedal has a wide range of gain from edge of break-up, clean-ish boost to aggressive overdrive.

Drive levels for both the op-amp overdrive and the power amp boost are controlled independently using two gain controls: “Suffering” sets the gain of the op-amp overdrive, “Abuse” sets the gain of the power amp boost.

The power amp boost is designed to enhance low end, compensating for the typical low-end cut that is shaped early in the op-amp overdrive circuit. Additional EQ adjustment is achieved with an active tilt tone control that can further emphasize low end, darkening the overall sound or boosting upper-mids and treble.

The output signal level of the pedal is controlled with a master volume which is loud enough to further overdrive the input of other pedals or amp.

For the most authentic grief-stricken Jimmy Bower tone, be sure to play on your bridge pickup with your guitar’s volume knob at max and tone knob rolled all the way off.


Features:

Controls

• Suffering: Adjusts the gain of the op-amp overdrive.
• Abuse: Adjust the gain of the solid state power amp boost.
• Volume: Adjusts the overall output level of the pedal.
• Tone: Active tilt EQ to boost bass or upper mid / treble frequencies.


Specs

• Relay-based, true bypass soft switching
• Adjustable LED brightness via internal trim pot (LED)
• Premium components including Neutrik input/output jacks, Lumberg power jack, ORMAT knobs, Alpha pots, sealed relay, metal LED bezel, and mil-spec aircraft grade wire
• Powder coated finish with clear coat and high gloss textured UV printed artwork
• 4.75” x 2.625” x 2.375”
• 9.7oz
• Power: Use only a standard 9v DC power supply with a 2.1mm negative-center barrel. An isolated power supply is recommended. Power supply not included